Телефон: +7 (937) 519-34-24

 

Use this tutorial to power the LEDs from a separate power source (NOT the receiver) using the microBRAKE™ 6 LED Controller.

This tutorial uses the 3 wire power plug and RX Pass-Thru™ included with the microBRAKE™ 6 LED Controller.

Remove Blue Wire

Step #1:

Remove the blue wire from the 3 wire power plug.

Remove the 2x2P connector housing and replace with a 2P connector housing.

If no 2P housing is available cut the second row from the 2x2P housing to convert it to a 2P housing.

To remove connector terminals from the connector housings use an XACTO knife.

Plug Into RX Pass-Thru

Step #2:

Plug the 3P connector housing into the RX Pass-Thru™, black-black; white-white.

Plug Into microBRAKE LED Controller

Step #3:

Plug the separate power source positive (+) lead into the top pin of PWR, and the negative(-) lead into the bottom pin of PWR.

Plug the 2P connector housing from the modified 3 wire power plug into the AUX channel, black-top; white-bottom.

Plug Into RX

Step #4:

Plug the RX Pass-Thru™ into the receiver.

Tutorial Complete!