Телефон: +7 (937) 519-34-24

 

Use this tutorial to power the LEDs from a separate power source (NOT the receiver) using the NIGHTFLY™ or NIGHTFLY2™ 14 LED Controllers.

This tutorial uses the 4 wire power plug included with the NIGHTFLY™ and NIGHTFLY2™ 14 LED Controllers.

Remove Blue Wire

Step #1:

Remove the blue wire from the 4 wire power plug.

To remove connector terminals from the connector housings use an XACTO knife.

Plug Into NIGHTFLY LED Controller

Step #2:

Plug the separate power source positive (+) lead into the top pin of PWR, and the negative(-) lead into the bottom pin of PWR.

Plug the 2x2P connector housing (notch up) into the other set of PWR and AUX channels, black-bottom-PWR; white-bottom-AUX; grey-top-AUX.

Plug Into RX

Step #3:

Plug the other ends of the 4 wire power plug into the receiver's two channels tied to 2-position switches on the TX.

Tutorial Complete!