Телефон: +7 (937) 519-34-24

Use this electronic switch to toggle power on/off to any axillary on-board device using a 2-position switch on the TX (transmitter) tied to an available channel on the RX. Two identical output channels for connecting up to 2 LED Controllers.

Pins can be soldered to for a hardwired connection. Pins can also be removed if they will not used.

RPS output pins align with the WHITE-RED-BLACK wires of the switch itself. The WHITE output pins are the SWITCHED GROUND (-) connection that actually toggles power to the connected device(s). The RED output pins are POSITIVE (+), the same positive as the RX it is plugged into. The BLACK output pins are constant GROUND (-), the same ground as the RX it is plugged into.Remote Power Switch

For standard +/- switching use included 1x2P housings to convert the 3 wire link cable into a standard wire extension by removing the black wire from the assembly. Then plug the blue wire into RPS top or bottom row of output pins following polarity BLUE-RED, WHITE-WHITE. Then plug lights (or other device) into the other end of the wire extension POSITIVE-BLUE (TOP PWR PIN); NEGATIVE-WHITE (BOTTOM PWR PIN ON LED CONTROLLERS).

If a RX Direct2LED™ will be used, discard or save the 3 wire link cable for future use.  Plug the RPS into an available RX channel tied to a 2-position switch on the TX. Plug the 1x3P connector side of the link cable (or RX Direct2LED™) into RPS top or bottom row of output pins. Use wiring polarity BLACK-BLACK, BLUE-RED, WHITE-WHITE with the link cable. For RX Direct2LED™ use wiring polarity RED-RED, BLACK-WHITE. Plug the 2x2P connector side of the link cable into the 10 LED Controller; jumper removed, notch UP.

LED CONTROLLER OPTION SELECTION DIP SWITCHES

LEFT SWITCH (1) AUTO-OFF AT SIGNAL LOSS : If enabled all power to the outputs is switched OFF any time a bad signal is recieved, or the TX is turned off (this feature is generally disabled for most lighting applications).

RIGHT SWITCH (2) SIGNAL REVERSE : Reverses the TX signal input (changes which position of the TX 2-position switch is ON)

SWITCH OUTPUTS

TOP ROW (SIDE WITH SWITCHES) LIGHTS : WHITE-WHITE, BLUE-RED, BLACK-BLACK (3 WIRE LINK CABLE); BLACK-WHITE, RED-RED (RX DIRECT2LED)

BOTTOM ROW SAME AS TOP ROW

3 WIRE LINK CABLE TO RPS CONNECTION

3P TO Remote Power Switch

RX DIRECT2LED™ TO RPS CONNECTION

RX Direct2LED TO Remote Power Switch

RPS SWITCHING AUX LED CHANNELS ON 10 LED CONTROLLER

Remote Power Switch 10 LED Controller

RPS SWITCHING ALL CHANNELS ON 10 LED CONTROLLER (STANDARD SWITCHING)

Standard Switching the Remote Power Switch
Standard Switching Remote Power Switch Connection

WIRE COLOR (TO RPS)

BLUE - POSITIVE (TOP PWR PIN ON LED CONTROLLER)
BLACK - FIXED GROUND (BOTTOM PWR PIN ON LED CONTROLLER)
WHITE - SWITCHED GROUND (BOTTOM AUX PIN ON LED CONTROLLER)

WIRE COLOR (TO RX)

RED - POSITIVE
BLACK - GROUND
WHITE - SIGNAL