Телефон: +7 (937) 519-34-24

RCL5422E Step by Step

2 LED ELECTRONIC BRAKE LIGHTS - RED [3MM, 14”]

STEP 1 STEP 2
Locate the two 14” Wire Extensions, two 3mm Red LEDs, two 2P housings, and one 3x2P housing. Remove housings from each end of the 14” wire extensions. Following Plug and Play Connector – Heavy Duty Off-Road Use Assembly Instructions assemble the LED side of each wire extension. Then insert each wire extension into the 3x2P housing keeping both positive-blue on one side and both negative-black on the other. Plug the 3x2P housing into the RX Direct2LED™ blue-top-+; black-bottom. Plug the RX Direct2LED™ into the Electronic Brake Switch bottom row (side without switches) red-red, black-white. Picture shows this step completed.
STEP 3 STEP 4
Insert LEDs into RPM LED Canisters. Or use included 3mm LED holders to mount LEDs though body for standard installations. If desired, wires can be twisted together prior to installing LEDs into canisters. Use zip ties or aluminum tape to secure wires together. Picture shows this step completed. Plug the EBS into the throttle channel of the RX. Plug ESC or throttle servo into the open set of pins (side with switches) following polarity, red-red; black-black; white-white. Use remaining aluminum tape, zip ties, and bases to secure all loose wires. If using with Standard 10 LED Controller (#RCL5051) use the 1-Channel RX Plug instead of the RX Direct2LED™.
Before you begin installation onto the vehicle/body: completely read through these instructions, setup/configure your lighting system, and test it to ensure proper operation. Before ever applying power to the LEDs check & double-check your wire connections to ensure the LEDs are plugged into the right channels on the LED controller. LEDs blown due to incorrect installation wiring are not covered by warranty. Connecting LEDs directly to power will blow them immediately.
WARNING: LED lights are designed to be used in extreme nighttime and low visibility running environments and are very high output. DO NOT look directly into beam.
WIRING DIAGRAM