DOWNLOAD- PDF Tech Sheet
Use to connect up to 10 LEDs directly to any available channel on the RX (receiver).
Pins can be soldered to for a hardwired connection. Pins can also be removed if they will not used.
Plug the Standard 10 LED Controller into any available channel on the RX, or use any 3.6-7.4VDC power source. If no extra channels are available on the RX use a RX Pass-Thru™.
Align BLUE wires with the top side of the Standard 10 LED Controller.
1 LED 1-6 : HEAD, FOG, RUNNING, UNDER-GLOW, CONSTANT NAVIGATION
2 AUX 1-4 : BRAKE, LANDING, or ADDITIONAL CONSTANTS USING INCLUDED JUMPER
PWR 3.6-7.4VDC POWER INPUT (NEVER PLUG A LED IN HERE, USE ONLY TO LINK LED CONTROLLERS OR POWER THE LED CONTROLLER)
LED1-6 CONSTANTLY DRIVE ANY SINGLE LED, ALL CHANNELS ARE EXACTLY THE SAME (LED BANK 1)
AUX INPUT USED TO SWITCH AUX1-4 LED CHANNELS (ON/OFF USING RPS, ON/DIM USING EBS)
AUX1-4 CONSTANTLY DRIVE ANY SINGLE LED, ALL CHANNELS ARE EXACTLY THE SAME (LED BANK 2)
RESISTOR IN CIRCUITRY
ELECTRICALLY CONNECTED
+ POSITIVE VOLTAGE FROM POWER SOURCE
- NEGATIVE GROUND FROM POWER SOURCE
R+ POSITIVE OUTPUT WITH INLINE RESISTOR
AR- NEGATIVE OUTPUT WITH INLINE RESISTOR (AUX SWITCHED)
A CONNECT TO GROUND TO POWER AUX1-4 LEDS (usually to the pin above it, using supplied jumper)
RED - POSITIVE (TOP PWR PIN ON LED CONTROLLER)
BLACK - GROUND (BOTTOM PWR PIN ON LED CONTROLLER)
BLUE - POSITIVE
BLACK - GROUND