Телефон: +7 (937) 519-34-24

DOWNLOAD- PDF Tech Sheet

Use to connect up to 6 LEDs directly to the throttle channel on the RX (receiver) using the included RX Pass-Thru™ with dual intensity brake light action built right in.

Pins can be soldered to for a hardwired connection. Pins can also be removed if they will not used.

Plug the microBRAKE™ 6 LED Controller into the throttle channel of the RX by plugging the link cable into PWR & AUX channels on the LED controller with the rib UP.  Plug the other end into the RX Pass-Thru™ along with the throttle servo or ESC.  Then plug the RX Pass-Thru™ into the throttle channel of the RX.

If a separate power source (3.6-7.4VDC) will be used, plug it into the PWR channel.  Then remove the BLUE wire from the link cable and insert the BLACK wire directly above the WHITE wire on the AUX channel. Remove extra positions from the 2x2P connector housing so it is a 1x2P housing.

Align BLUE wires with the top side of the microBRAKE™ 6 LED Controller. microBRAKE 6 LED Controller Installed

LED CONTROLLER BANKS

1 LH, LF, RF, RH : HEAD & FOG

2 LB, RB : BRAKE

LED CONTROLLER CHANNELS

PWR 3.6-7.4VDC POWER INPUT

LH, LF, RF, RH CONSTANTLY DRIVE ANY SINGLE LED, ALL CHANNELS ARE EXACTLY THE SAME, CONSTANT ON (LED BANK 1)

AUX THROTTLE SIGNAL INPUT USED TO SWITCH LB & RB LED CHANNELS DIM / FULL BRIGHT (top pin ground, bottom pin throttle signal)

LB, RB CONSTANTLY DRIVE ANY SINGLE LED, ALL CHANNELS ARE EXACTLY THE SAME, LEDs WILL BE DIM UNLESS THROTTLE SIGNAL INDICATES BRAKES; IN WHICH CASE LEDs ARE FULL BRIGHT (LED BANK 2)

LED CONTROLLER OPTION SELECTION DIP SWITCHES

BL BRAKE LIGHTS : Brake lights dim/full intensity at center-stick (choose if brake lights are on or off at idle)

TR THROTTLE REVERSE : Reverses the throttle signal input (if brake lights turn on with gas then flip this switch)

microBRAKE 6 LED Controller RX Pass-Thru

PINOUT LEGEND

RESISTOR RESISTOR IN CIRCUITRY

CONNECTION ELECTRICALLY CONNECTED

IC INTEGRATED CIRCUIT

microBRAKE 6 LED Controller

+ POSITIVE VOLTAGE FROM POWER SOURCE

- NEGATIVE GROUND FROM POWER SOURCE

R- NEGATIVE OUTPUT WITH INLINE RESISTOR

AR- NEGATIVE OUTPUT WITH INLINE RESISTOR (AUX SWITCHED)

A THROTTLE SIGNAL INPUT

TOP PINOUT

5052 Top Pinout 

BOTTOM PINOUT

5052 Bottom Pinout

WIRE COLOR (TO RX)

BLUE - POSITIVE (TOP PWR PIN ON LED CONTROLLER)
BLACK - GROUND (BOTTOM PWR PIN ON LED CONTROLLER)
WHITE - SIGNAL (BOTTOM AUX PIN ON LED CONTROLLER)

WIRE COLOR (TO LEDs)

BLUE - POSITIVE
BLACK - GROUND